Inner Layer Clearances
We require a minimum of 0.010" inner layer clearance.
Copper to Edge of Printed Circuit Board
Minimum of 0.010" (outer layers) and 0.015" for inner layers (0.020" preferred for inner layers). For scoring, minimum of .015 for outer layers and .020 for inner layers
Pad Size/Annular Ring
Pad size should be at least + 0.010" over finished hole size for vias and + 0.014" over finished hole size for component holes. This means the annular ring (radius of the pad) should be at least .005" for vias and a minimum of 0.007" for component holes.
+/- 0.005" Standard Spec (applies to holes up to .250", larger holes will be routed, see Rout tolerances below)
+/- 0.005" Custom Spec
+/- 0.003" Custom Spec upon request 1 oz and 2 oz finished copper weight and 3 oz finished copper weight (when starting with 2 oz foil) only.
If your hole tolerances are zero (see below), then Advanced Circuits will assume that you are OK with our default hole tolerance. Our default hole tolerance is listed above.
Example: Customer Drill Chart with Zero Hole Tolerance
Our minimum finished hole size; 0.008". Call your salesperson if you required a finished hole size less than 0.008".
Printed Circuit Board Thickness:
Thickness tolerances may vary 10% (min.+/- 0.005")
Minimum Board Thickness
|Thickness||Default||File Review Req.|
PCB Inner Layer Thickness
Tolerances do not apply to the inner layers of prototypes.
Rout (Board Outline and Internal Cutouts)
The Outer Layer Tolerances on Standard Spec defined boards is +/- 0.010" (+/- 0.005" available for Custom Spec upon request)
Note: We rout to your board size using the center of the board outline on your mask layer.
Copper Trace Width/Spacing (Trace and space)
Copper spacing is the minimum air gap between any two adjacent copper features. Trace width is the minimum width of a copper feature, usually traces.
Requirements: A premium is charged for trace width/spacing less than .007".
(We can process .004" for 1 oz. CU. finished (outer layers) and .5 oz. CU finished (inner layers).
For 1 oz. finished copper weight (inner layers), the minimum trace width/space is 0.005"
For 2 oz. finished copper weight (inner & outer), the minimum trace width/space is 0.006"
For 3 oz. finished copper weight (inner & outer), the minimum trace width/space is 0.010"
For 4 oz. finished copper weight (inner & outer), the minimum trace width/space is 0.012"
Note: Advanced Circuits does not offer weights such as 1.5 or 2.5 ounce finished on standard and custom spec orders.
Trace Width/Air Gap
The greater of +/- 20% or +/- 0.002"
This is the expansion of mask relief over pad area. Our minimum is 0.005" over pad dimension or 0.0025" each side. Advanced Circuits will modify files to meet the minimum dimension.
Minimum 0.031" in width. For smaller width, call your salesperson for pricing and turntime.
Tab Rout Spacing
Please allow 0.100" spacing between your individual pcbs for tab rout spacing. When scoring there should be no spacing between boards.
0.005" minimum line width.